Power Control Solar

The sun rises here: SmartHome Power Control solar tells you everything about the energy that you generate yourself with your solar power system. You can also easily keep an eye on your own consumption and the amount of electricity fed into the grid. But the solar power duo consisting of a reading and receiving unit can do even more. If there is sufficient solar power, the washing machine and dryer, for example, switch on automatically. This is how you easily go from being an electricity consumer to becoming an energy manager.

  • Evaluation and visualization of your electricity consumption and your solar power generation
  • Secure communication via encrypted radio protocol
  • Easy to install, set up and control
  • Also works fully locally: The local SmartHome

Power Control

  • Sends data from digital electricity meters to SmartHome receiving unit
  • Representation of your own use of green electricity through the solar system or amount of feed-in to the grid
  • Easy installation thanks to magnetic adhesion

Receiving unit

  • Receives meter data from SmartHome Power/Energy Control
  • Quick connection to the SmartHome central unit via USB interface

Prerequisites

  • SmartHome central

Box contents

  • Power control (2x) incl. receiving unit
  • Antenna with magnetic base
  • Adhesive pad for PC
  • Battery 3 V CR2450 (1x)
  • Micro USB charging cable
  • Power plug with USB port
  • User instructions

Technical data

Radio frequency 868 MHz (W-Mbus Mode S1-m); compliant with OMS
Max. Transmission power 13dBm
Recipient class SRD Class2
Nominal voltage Max: 5V, limited power supply
Rated current • Max.: 60mA
• Average typically 1.5mA (reading interval 10 seconds)
• Average typically 150μA (reading interval 180 seconds)
Protection class IP20
Dimensions (Without stand) 32 x 40 mm (Ø x H)
Weight (without cable) 20g
Typical ambient temperature +0°C to +55°C
Read protocol type SML

Installation and commissioning

To ensure reliable reading and transfer of the meter data, please proceed as follows:


< /p>

1. Place the reading unit on the infrared data interface of your electronic household meter (EDL21). The magnetic ring ensures a secure hold. If necessary, use the adhesive pad provided.
2. Plug the supplied antenna into the antenna socket. Then align the antenna vertically. For the best possible reception, make sure that the antenna is installed outside the meter cabinet, if possible. Ideally, place the antenna on the meter cabinet.
3. Establish a power supply using the MicroUSB charging cable. To do this, connect the MicroUSB port to the readout unit and the power plug and plug it into a 230V socket. If there is no outlet in your fuse box, you can use a battery pack.
4. Plug the receiving unit into your control center. The Power Control is now ready for operation and can be integrated into the user software.

Compatibility list

The Power Control solar is used to connect an electrical household meter (also called SmartMeter) to your SmartHome. The prerequisite for this is a digital electricity meter of type EDL21 with an infrared data interface. The SML communication protocol is used to securely read and transmit the meter data.


Two two-way meters used at the same time, regardless of manufacturer, are not supported.


Manufacturer Serie
AEM eHZ E3L AW11112
EMH eHZ-G ...
eHZ-H ...
eHZ-I …
eHZ-K ...
ED 300 L ...
ED 100 L ...
Hager eHZ 162 ...
eHZ 163 ...
eHZ 362 ...
eHZ 363 ...
ISKRA MT681 ...
MT175 .
Easymeter Q3C ...
AEM 3HZ E3L ...
eHZ E3L ...
Dr. Neuhaus SMARTY ix-110 ...
SMARTY ix-330 ...

Zurücksetzen

Factory Reset Devices

Downloads

Bedienungsanleitung