Motion detector (outdoor)

Garden, terrace, house entrance and driveway – you can also achieve a lot outside of your four walls. Attach the motion detector (outdoor) and use it to control lamps and electrical appliances. By varying the infrared sensor, unintentional triggering (e.g. by pets) can be avoided.

  • Reacts to movement and brightness
  • Detection range of up to 9 meters
  • Weatherproof
  • Can be combined with all SmartHome devices
  • Easy to install, set up and control
  • Also works fully locally: The local SmartHome

Prerequisites

  • SmartHome central

Box contents

  • Motion detector (outdoor)
  • Batteries 1.5 V LR06/Mignon/AA (3x)
  • Fastening material for wall mounting
  • User instructions

Technical data

Device name WMDO
Power supply 3xLR6 (AA) (Mignon)
Battery life approx. 2 years
Max. Transmission power 10mW
Radio frequency 868.3MHz
Open field range approx. 100m
Recipient class SRD Class2
Protection class IP44
Ambient temperature -20°C to +55°C
Dimensions 96x70x90mm (WxHxD)
Weight 160g

Installation and inclusion

Before installation, please note the serial number in the battery compartment (12 digits under the barcode) and the exact installation location. You will need this for later integration into your SmartHome.


To reduce the risk of accidental activation, the motion detector must not be exposed to direct sunlight, car headlights, etc., nor installed near a heat source. Align the detection area against a wall or the floor, but not directly at windows or heat sources.

Mounting the wall bracket

  • Unlock the wall bracket from the base device of the SmartHome motion detector by simultaneously pressing (in the direction of the arrow) the unlocking button (see (F) in the illustration).
  • Pull the wall bracket (see (C) in the illustration) upwards from the base device of the SmartHome motion detector.
  • Position the wall mount in a suitable location on a wall.
  • Mark the corresponding drill holes of the wall bracket through the screw holes.
  • Drill a hole 5 mm wide and 35 mm deep.
  • Insert the dowels (included).
  • Hold the wall bracket in front of the drill holes.
  • Attach the wall bracket with the screws.
  • Insert the batteries into the base device. To use the base device.
  • Push the base device onto the wall bracket from below until it clicks into place.

Device inclusion

Start the SmartHome app or log in. Now connect the device via +. Alternatively, you can search for and integrate the device using the device selection.

Reset

Factory Reset Devices

Downloads

User instructions